Type: Internal (1.0 and later)
Purpose: Displays current date setting and provides a
way to reset the date.
You can enter the DATE command alone and the program will prompt you when
to enter the date. You can also enter the date at the same time you enter
the date command. Either way, you must enter the date in the following
The date you set will be used by DOS to “date stamp” files that are created or modified. This date will be shown when you use the DIR command to display information about files.
You can specify the numbers to set the date at the same time you enter the DATE command or you can enter the command alone and the program will prompt you to enter the date.
For information on using the PROMPT command to display the date, refer to Chapter 6, Tips for Advanced Users.
When you enter
if the current date is set the program will display
Current date is Sat 06-11-1994
Enter new date (mm-dd-yy):
Press Enter to leave the date as it is, or type in the date using the format shown. Be sure to enter one or two numbers to indicate the month, then a hyphen, one or two numbers to indicate the day of the month, another hyphen, and one or two numbers to i
ndicate the year. For example, to set the date on May 24, 1994, enter
Back to the